Stratasys Objet1000 Plus - Page 193

Objet1000 Plus User Guide 6 Operating and Maintaining the Objet1000 Plus 3DPrinter
DOC-06810 Rev.B 6-73
TheBuilt In Testsscreenlistspre-configuredtests,groupedbycomponent
categories.Inthisscreen,youselectandruntests,andtheresultsare
displayed.
Figure6-115Built In Testsscreen
Test List Test Name
Thiscolumnlistsallofthetests,togetherwithselectioncheckboxes.
Clickthecheckboxestoselectthetestsyouwanttorun.Toremovea
selection,clickthecheckboxagain.Toquicklyselectallofthetestsina
componentcategory,usetheGroupdrop-downlistatthebottomofthe
screen.
Group
Thiscolumnshowsthecomponentcategoriesforeachtest.
ThistellsyouwhichtestsarerunwhenselectingacategoryfromtheGroup
drop-downlistatthebottomofthescreen.
Status
Thiscolumnshowstheresultsofeachtestafteryourunit:
Testsuccessfullycompleted.
Testfailed.(Double-clickonafailedtest’slinetoreviewthefailuredetails.)
Unknownresults.(Thetesthasnotbeenrunyet.)