Stratasys Objet1000 Plus - Page 65

Objet1000 Plus User Guide 5 Using Objet Studio
DOC-06810 Rev.B 5-30
Fine-SurfaceRule
Thisruleconsidersmodelsthathaveonesideonwhichtherearefinedetails
(likethekeypadsideofatelephone).
➢ Thesideofthemodelcontainingfinedetailsshould,whenpossible,be
positionedface-up.Thisresultsinasmoothfinish.
AvoidSupport-MaterialRule
Thisruleconsidersmodelsthathavelargeholesorhollows,openonatleast
oneside(likeapipeoracontainer).
➢ Itmaybeadvantageoustoprintamodelstanding up,soSupportmaterial
doesnotfillthehollow,eventhoughprintingthemodellyingdownwould
bemuchfaster.