Suzuki DF70A - Page 253

Housing and Bracket: 2A-11
Engine Holder / Oil Pan
• Position the clutch rod (1) into place.
• Install engine holder / oil pan to steering bracket.
• Install washer (2) and upper mount nut (1), then
tighten two nuts, pre-coated with thread lock, to
specified torque.
Tightening torque
Upper mount nut (a): 80 N·m (8.0 kgf-m, 57.8 lbf-
ft)
: Thread lock cement 99000–32050 (SUZUKI
Thread Lock 1342 (50 g))
Clutch Rod
• Slide the clutch rod (1) into place.
• Tighten the clutch shaft plug (2), pre-coated with
thread lock, to specified torque.
Tightening torque
Clutch shaft plug (a): 22 N·m (2.2 kgf-m, 16.0 lbf-
ft)
: Thread lock cement 99000–32050 (SUZUKI
Thread Lock 1342 (50 g))
Water Pressure Valve
• Install water pressure valve (1) and cover (2). Refer to
“Water Pressure Valve Removal and Installation” in
Section 1F (Page 1F-4).
1
I9J011210047-01
I9J011210048-01
(a)
1
2
I9J011210049-01
1
I9J011210050-01
(a)
2
I9J011210051-01
1
2
I9J011210052-01
http://SelfFixer.com