097-93100-01 Revision C – February, 2010 TimeCreator 1000 User’s Guide 213
Appendix B Command Descriptions and Communications Interface
CLI Commands
Related: set interface
Level : User, Power-User and Admin
Set Interface
Use this command to provision the port state to be enabled or disabled for the GPS,
client, or server ports. You can provision ports A/11 and B/12 as either DTI client
ports or DTI server ports and you can also provisions the priority levels. You can
provision the DTI server ports to be in test mode.
Command Syntax:
To provision the port state for the GPS or other ports to be enabled or disabled -
set interface state {gps|port #|all} {enable|disable}
To enable or disable the test-mode for the DTI server ports -
set interface test-mode (port #|all} {enable|disable}
To provision the TOD mode as short or verbose -
set interface tod-mode {short|verbose}
To provision Port A and Port B as client or server -
set interface type {porta|portb} {client|server}
To set the priority value for Port A or Port B -
set interface priority {porta|portb} <value>
Example 1:
To enable the GPS port -
tc1000>set interface state gps enable
Example 2:
To enable Port 5 for test mode -
tc1000>set interface test-mode port 5 enable
Example 3:
Note: With the 8-port IOC module option, only DTI Ports 1 through 6
are active, in addition to Port A/11 and Port B/12.
To Next Page
Loading...
Need help?
General
