Symmetricom TimeCreator 1000 User Manual

242 TimeCreator 1000 User’s Guide 097-93100-01 Revision C – February, 2010
Appendix B Command Descriptions and Communications Interface
CLI Commands
Show Remote-syslog
This command displays the remote syslog server(s) that log messages are sent to
from the TimeCreator 1000.
Command Syntax:
show remote-syslog
Example:
To display the remote syslog server(s) that log messages are sent to from the
TimeCreator 1000 -
tc1000>show remote-syslog
Related: set remote-syslog
Level : User, Power-User and Admin
Set Remote-syslog
This command is used to configure the remote syslog servers (maximum 8) to
receive log messages from the TimeCreator 1000.
Command Syntax:
 To add a new remote syslog server:
set remote-syslog add <hostaddr>
 To delete a specific remote syslog server or all of them:
set remote-syslog delete {<hostaddr>|all}
Example 1:
To add a remote syslog server at IP address 192.168.33.75:
tc1000>set remote-syslog add 192.168.33.75
Example 2a:
To delete the remote syslog server at IP address 192.168.33.77:
tc1000>set remote-syslog delete 192.168.33.77
Example 2b:

Symmetricom TimeCreator 1000 Specifications

General

Brand	Symmetricom
Model	TimeCreator 1000
Category	Server
Language	English