246 TimeCreator 1000 User’s Guide 097-93100-01 Revision C – February, 2010
Appendix B Command Descriptions and Communications Interface
CLI Commands
Set Root-recovery Autorecoverymode
This command is used to enable or disable the auto recovery mode (a global
setting) for root server recovery, or to abort the root server recovery process.
Command Syntax:
set root-recovery autorecoverymode [enable|disable|abort]
Example
To enable the auto recovery mode for root server recovery:
tc1000> set root-recovery autorecoverymode enable
Related: show root-recovery config
Level : Power-User and Admin only
Note: This command is only applicable for a TimeCreator 1000 that is
being used as a root server in T
OD Source mode of USER.
To Next Page
Loading...
Need help?
General
