097-93100-01 Revision C – February, 2010 TimeCreator 1000 User’s Guide 251
Appendix B Command Descriptions and Communications Interface
CLI Commands
To provision the state of Syslog:
set service syslog {enable|disable}
To provision the state of SNMP:
set service snmp {enable|disable}
Example:
To enable SNMP:
set service snmp enable
Remarks: Services include EIA-232, Telnet, FTP, SSH, NTP, Syslog, and SNMP.
Level : Power-User and Admin only
Note: The command also includes the capability of controlling the
syslog service. Disabling this service is not recommended.
To Next Page
Loading...
Need help?
General
