Symmetricom TimeCreator 1000 User Manual

270 TimeCreator 1000 User’s Guide 097-93100-01 Revision C – February, 2010
Appendix B Command Descriptions and Communications Interface
Simple Network Management Protocol
 Enable and disable SNMPv2c
 Set SNMP destination IP addresses for traps
 Display SNMPv2 community names, SNMPv3 user names, and assigned trap
destinations
 Add/Delete SNMPv3 user names
Enabling SNMP
The Set Service Snmp command allows you to enable or disable the SNMP (see
Set Service, on page 250).
Example:
Use the following command to enable SNMP:
Type
set service snmp enable and press ENTER.
Adding a Trap Destination IP Address
The “set snmp trap” command allows you to specify an SNMP trap destination IP
address (see Set SNMP, on page 253).
Example 1:
Use the following command to add a trap (SNMPv2) destination IP address
192.100.100.100:
Type
set snmp trap add 192.100.100.100 then press Enter.
Example 2:
Use the following command to add a trap (SNMPv3) destination IP address
192.100.100.100 for a v3 user named “v3user1”:
Type
set snmp trap add 192.100.100.100 v3user1 then press Enter.
Adding and Removing SNMPv3 Users
The “set snmp accessv3” command allows you to add or remove SNMPv3 users
and specify access privileges using algorithm HMAC-SH-1-96 or MD5 with the 20
character authentication key and a CBC-DES 16 or AES character privacy key (see
Set SNMP, on page 253).
Example
Use the following command to add user ABC with the 20 character MD5
authentication key 123456789ABCDEFGHIJK and 16 DES character privacy key
123456789ABCDEFG.
Type
set snmp accessv3 add abc SecureLvl priv AccessLvl rw and press
Enter.

Symmetricom TimeCreator 1000 Specifications

General

Brand	Symmetricom
Model	TimeCreator 1000
Category	Server
Language	English