Tandy 1400LT - Battery Pack; Base Frame; Battery Connector Removal; Right Side of Base Frame

11-5. Battery Pack
(1) Disconnect the Battery connectors and remove the Battery Pack. (Figure 2-12)
NOTE: Be careful not to short-circuit the terminals or wires of the Battery Pack.
\
Battery Connector
Battery
Connector (PCB Side)/
Figure 2-1 2. Battery connector Removal
11-6. Base Frame
(1) Turn over the Bottom Case, peel off two screw seals with tweezers and remove two Base Frame screws. (Figure
2- 13)
FDD
7
P/S PCB Cover
-
Base Frame
I Base Frame Screw
/
Screw Seal
Case
Figure 2-13. Right Side of Base Frame
2-1