ETH COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
337
eth bridge vlan iflist Display all vitual LAN's. see page 394
eth bridge xtratag add Add an extra tag mapping entry. see page 395
eth bridge xtratag config Configure an extra tag mapping entry. see page 396
eth bridge xtratag delete Delete an extra tag mapping entry. see page 397
eth bridge xtratag flush Flush all extra tag mapping entries. see page 398
eth bridge xtratag list Display all extra tag mapping entries. see page 399
eth device ifautoneg Adapt/list an Ethernet port's autonegotiation
parameters (if autonegotiation
see page 400
eth device ifconfig Configure an Ethernet port's type setting
(disable/enable autonegotiation).
see page 401
eth device iflist Show all Ethernet ports' operational status. see page 402
eth device ifrestart Reset an Ethernet port and restart
autonegotiation.
see page 403
eth efm flush Flush all EFM interfaces. see page 404
eth efm iflist Display the EFM interfaces. see page 405
eth efm ifreset Delete all configuration related to this EFM
interface.
see page 406
eth efm qos config Configure Qos entry of EFM interface. see page 407
eth efm qos list Display the Qos list. see page 408
eth efm qos queue config Configure TX Queue entry. see page 409
eth efm qos queue list Display the Qos list. see page 410
eth filter operand add Add a filter operand. see page 411
eth filter operand config Set the operand to a certain type (will reset
content first).
see page 412
eth filter operand delete Delete a filter operand. see page 414
eth filter operand flush Remove all filter operands (this will only delete
the ones not in use: flush
see page 415
eth filter operand frameclassadd Add another frameclass in the set. see page 416
eth filter operand frameclassdelete Delete a frameclasse from the set. see page 417
eth filter operand ipprotoadd Add another ip protocol in the set. see page 418
eth filter operand ipprotodelete Delete a ip protocol from the set. see page 419
eth filter operand list Display the filter operands. see page 420
eth filter operand priorityadd Add another priority in the set. see page 421
To Next Page
Loading...
Need help?
General
