ETH COMMANDS
338
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
eth filter operand prioritydelete Delete a ip priority from the set. see page 422
eth filter operand reset Reset an operand to its default initial state
(removes all content, set to
see page 423
eth filter operand vidadd Add another VID in the set. see page 424
eth filter operand viddelete Delete a VID from the set. see page 425
eth filter template add Add a filter. see page 426
eth filter template config Config a filter. see page 427
eth filter template delete Delete a filter. see page 428
eth filter template flush Remove all filters. see page 429
eth filter template list Display the filters. see page 430
eth filter template ruleadd Connect an operand rule with a filter. see page 431
eth filter template ruledel Remove an operand rule from a filter. see page 432
eth filter template rulemodify Modify an operand rule from a filter. see page 433
eth filter template setpriority Action: enable/disable priority derivation see page 434
eth filter template setvid Action: enable/disable VID derivation see page 435
eth flush Flush all ETH interfaces. see page 436
eth ifattach Attach an ETH interface. see page 437
eth ifconfig Modify an ETH interface. see page 438
eth ifdelete Delete an ETH interface. see page 439
eth ifdetach Detach an ETH interface. see page 440
eth iflist Display the ETH interfaces. see page 441
eth oam add Enable Ethernet OAM (E-OAM) on an
interface.
see page 442
eth oam config Modify global E-OAM configuration. see page 443
eth oam configlist Display global E-OAM configuration. see page 444
eth oam debug configlist Display E-OAM debug configuration. see page 445
eth oam debug nc-events Generate non critical event errors. see page 446
eth oam debug traceconfig Modify E-OAM trace level. see page 447
eth oam delete Disable E-OAM on an interface. see page 448
eth oam ef-event Configure Errored Frame Event. see page 449
eth oam efp-event Configure Errored Frame Period Event. see page 450
To Next Page
Loading...
Need help?
General
