Tektronix GeoProbe G10 User Manual

G10 Hardware Maintenance Guide 7.13.2 125 
5
Maintenance Guidelines
Rev. 002-140228
7. Power off the storage arrays:
 Power off the controller enclosure first and then the expansion
enclosures.
 Press the power switches to the OFF position on both power modules at the
back of each enclosure.
STORAGE ARRAY MAINTENANCE PROCEDURES
This section contains the following procedures:
 Replacing a Power Supply
 Bezel (Air Filter) Procedures
 Replacing a Controller or Expansion Module
 Replacing a Drive Module
 Replacing the Disk Array Chassis
Electrostatic discharge can damage circuits or shorten their life. Before touching blade or
electronic components, make sure that you are working in an ESD-safe environment and
wearing an ESD wrist or foot strap.
Storage Array Maintenance Guidelines
The G10 supports the following storage enclosures:
 RAID: SA100R or SA200R
 JBOD: SA100J, SA200J, SA210J
Please note the following guidelines when maintaining the storage arrays:
 An SA200 part must be replaced with an SA200 part.
 SA100 controllers can be replaced by SA200 controllers in an SA100 enclosure. Both
controllers must be replaced; you cannot mix controller models (one enclosure cannot
have one SA100 controller and one SA200 controller).
 SA100 parts are not compatible with the SA200 enclosure.
Tektronix Communications | For Licensed Users | Unauthorized Duplication and Distribution Prohibited

Tektronix GeoProbe G10 Specifications

General

Brand	Tektronix
Model	GeoProbe G10
Category	Accessories
Language	English