Telit Wireless Solutions ME910G1 - Page 530

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 530 of 545 2020-04-15
0
:
disable
1
:
enable
<GSV>
integer
0
enable/disable the presence of the Satellites in View NMEA
sentence (GSV) in the GNSS data stream.
Values:
0
:
disable
1
:
enable
<RMC>
integer
0
enable/disable the presence of the Recommended Minimum
Specific GNSS Data NMEA sentence (RMC) in the GNSS data
stream.
Values:
0
:
disable
1
:
enable
<VTG>
integer
0
enable/disable the presence of the GNSS Course Over Ground
and Ground Speed NMEA sentence (VTG) in the GNSS data
stream.
Values:
0
:
disable
1
:
enable
Additional info:
<enable>=1, GNSS data stream format:
$GPSNMUN: <NMEA SENTENCE 1><CR><LF>
...
$GPSNMUN: <NMEA SENTENCE N><CR><LF>
...
<enable>=2, GNSS data stream format:
<NMEA SENTENCE 1><CR><LF>
...
<NMEA SENTENCE N><CR><LF>
...
<enable>=3, in this case, the AT interface port is dedicated to NMEA sentences, it is not
possible to send AT commands. Use the escape sequence "+++" to return in command
mode. GNSS data stream format:
$GPSNMUN: <NMEA SENTENCE 1><CR><LF>
...
$GPSNMUN: <NMEA SENTENCE N><CR><LF>
...
The NMEA data stream format is the same as the one selected by <enable>=1.