Textron Jacobsen SLF530 - Page 248

6-54 673831-Rev A
HYDRAULICS
6
Disassembly, Inspection, and Assembly
See Figure 6-58.
Figure 6-58
NOTE
• Repair of the lift valve is limited to replacing valves
and cartridges or replacing O-rings.
• Record the location of the all cartridges before
removing to ensure correct installation.
1. Remove two coil nuts (6) and two solenoid coils (4).
2. Remove four solenoid valve screws (8) and solenoid
valve (3). Discard the four O-rings between solenoid
valve and valve body.
3. Remove relief valve (1).
4. Remove three check valves (2).
5. Remove three pilot pistons (7).
6. Remove four plugs (5) and gauge port plug (9).
1 Relief Valve 4 Solenoid Coil (2) 7 Pilot Piston (3)
2 Check Valve 5 Plug (4) 8 Solenoid Screw (4)
3 D03 Solenoid Valve 6 Coil Nut (2) 9 Gauge Port Plug
MAR0187
1
2
3
4
4
5
5
6
6
8
7
9