1-3
1
4st 25/30 2022
4) Genuine Parts
Use parts and/or chemicals that are genuine or
recommended. Be careful not to allow oil, grease or
sealing agent to adhere to the skin. In case of exposure
to such substances, wash away with soap or warm water
immediately.
5) Tools
Use specified special tools to avoid damaging parts and to
perform the work safely and reliably. Be sure to follow the
installation procedures described in this manual and use
the tightening torque specified.
6) Recommendations on service
Clean and remove foreign substances and dirt from the
outboard motor body and individual parts. Apply the
recommended oil or grease on rotating areas and sliding
surfaces. After carrying out each work, always conduct a
check to ensure smooth movement and sealing.
3R0728150
3AC728710
To Next Page
Loading...
Need help?
General
