7-33
4st 25/30 2022
7
Upper Rubber Mount Bolt:
13 N · m (9 lb · ft) [1.3 kgf · m]
4. Install the upper rubber mounts 6 and dampers 7 onto
the drive shaft housing and tighten the bolts 8.
Install the dampers in the orientations shown in
the diagram.
7)
Installation of Drive Shaft Housing Assy
1. Attach the damper 2 to the lower rubber mount 1, then
attach the drive shaft housing to the clamp bracket assy.
2. Tighten the upper mount nuts 3 to the specified torque.
3. Install the lower mount bolt 4 and lower mount nut 5.
Upper Mount Nut 3:
27 N · m (20 lb · ft) [2.7 kgf · m]
Lower Mount Nut 5:
27 N · m (20 lb · ft) [2.7 kgf · m]
Correctly align the bolt hole position of the
damper when installing.
To Next Page
Loading...
Need help?
General
