10
10-17
4st 25/30 2022
2) Installation of the Battery
Recommend connecting only the engine battery cables to
thestarting battery.
1. Battery should be stored in battery storage box and
secured to hull to prevent it from falling due to rolling or
pitching or any shock in the place where it is protected
from water spray.
8. The Electrical System
1) Battery Capacity
•
Before using battery, thoroughly read
warning label.
•
Do not disconnect battery cable during
engine operation.
Do not use a wing / butterfly nut for installing
the battery cable.
A wing / butterfly nut tends to get loose
easily, resulting in electrical failures.
Recommend to fasten with correct hex-
nut and if washer is needed possibly
locking washer or star washer to prevent
accidental loosening of nuts.
12 V 64 Ah/5 HR or higher
12 V 70 Ah/20 HR or higher
512 CCA or higher
2. When connecting battery cables, connect positive cable
(red) 1 first and then negative cable (black) 2. (Reverse
the order when disconnecting.)
Positive cable is the one with red tube on the terminal end.
To Next Page
Loading...
Need help?
General
