TOHATSU MFS 25d Service Manual

10
10-7
4st 25/30 2022
4. Connections to the Outboard
Motor
1) Steering Cable
Cable installed on the starboard side
1. Apply a thin coat of grease over the entire cable end.
2. Insert the steering cable into the tilt tube.
3. Tighten the nut to the specified torque.
Nut:
48 N·m (35 lb·ft) [4.8 kgf·m]
•
Be sure to install the drag link seal ring 1.
•
Do not overtighten the drag link seal ring or it
may deform and the telescopic shaft of steering
cable will not be sealed properly.

TOHATSU MFS 25d Specifications

General

Brand	TOHATSU
Model	MFS 25d
Category	Outboard Motor
Language	English