6
6-41
4st 25/30 2022
5. Install the shift rod joint, and connect the shift rod using a
new spring pin.
6. Install the shift rod joint retainer 4.
•
Double-check that the shift rod is fully raised.
In addition, check that the shift lever is in the
forward (F) position. (Shift lever is in contact
with stopper)
If the joint is not tightened in the correct
position, shifting in and out may become
difficult.
•
Install the spring pin with the opening facing up
or down.
Spring Pin Tool 3:
P/N. 345-72228-0
a Stopper
Apply water-resistant grease on the shift rod joint
retainer.
To Next Page
Loading...
Need help?
General
