Toshiba B-EP2DL Series System Mode Manual

1. INTRODUCTION EO13-33005
1.2 Operation Panel
1- 6
(8) LCD message and LED indication
LED Indicatio
n
No. LCD Message
STATUS
Printer Status
Restoration
by PAUSE
key Yes/No
Acceptance of
Status Request
Reset Command
Yes/No
ON LINE  Online mode ----- Yes
ON LINE  Online mode (communicating) ----- Yes
1
ON LINE
 Strip wait ----- Yes
2 COVER OPEN  The cover was opened in online state. ----- Yes
3 PAUSE ****  Pause state Yes Yes
4 COMMS ERROR ∆
A parity, overrun, or framing error has
occurred during a communication by RS-
232C.
Yes Yes
5 PAPER JAM **** ∆
A paper jam has occurred during paper
feed.
Yes Yes
6 NO PAPER **** ∆
The media has run out, or the media is not
loaded properly.
Yes Yes
7 NO PAPER ∆
The label has run out after issuing the label
successfully.
Yes Yes
8 COVER OPEN **** ∆
A feed or printing was attempted with the
Front Cover opened.
(except when the [PAUSE] key is pressed)
Yes Yes
9 HEAD ERROR ∆ The print head has a problem. Yes Yes
10 EXCESS HEAD TEMP ∆
The print head is overheated.
(71°C or more).
No Yes
11 SAVING ####&&&& 
In writable character or PC command save
mode
----- Yes
12 FORMAT ERROR ∆
An error has occurred in formatting the
flash ROM.
No Yes
13 FLASH WRITE ERR. ∆
An error has occurred in writing to the
flash ROM.
No Yes
14 FLASH MEM FULL ∆
Saving failed because of an insufficient
capacity of the flash ROM.
No Yes
15 EEPROM ERROR ∆
Data cannot be read from/written to a
backup EEPROM properly.
----- -----
16 LOW BATTERY
□
The battery voltage
7.2V or less
(B-EP2D model)
14.0V or less (B-EP4D model)
No Yes
17 AMBIENT TEMP ERR ∆
An ambient temperature is below -20°C or over
60°C.
Yes Yes
18 BATT. TEMP ERROR ∆
The battery is in a dangerous condition.
Care must be taken not to get burned.
No Yes
19 HIGH VOLT. ERROR ∆ The battery is in a dangerous condition. No Yes

Toshiba B-EP2DL Series Specifications

General

Brand	Toshiba
Model	B-EP2DL Series
Category	Printer
Language	English