4. SYSTEM MODE (For Service Persons and System Administrators) EO13-33005
4.6 Test Print
4- 58
(5) Paper Feed Mode Setting (PAPER)
This setting is used to feed a paper without performing printing in system mode where the [FEED] key is
invalid to feed a paper.
Notes:
1. When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE]
key is pressed.
2. When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
3. When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this setting, repeat
mode is enabled and the key pressed is repeatedly entered.
4. The change in the parameter setting becomes effective when the [POWER] key is pressed after
setting, then stored in the backup memory.
5. By selecting an option using the [FEED] key and determining it using the [POWER] key feeds the
paper by an amount specified by LABEL LEN. (See the previous section.). If the label length is not
specified, the paper is fed by 63 mm.
6. The default value at power on is NO FEED (Paper is not fed.).
TYPE AUTO
[FEED]
[PAUSE]
TYPE BATCH
Paper is not fed. (Factory default)
Paper is fed.
To Next Page
Loading...
Need help?
General