System & Station
Program 60-2~6 & 9 SMDR Output/Account Code Digit Length
3-108
Strata DK40 Programming Manual Spring 1999
Program 60-2~6 & 9
SMDR Output/Account Code Digit Length
Program Type:
System
Initialised Default:
Item 2: 10 seconds
Item 3: SMDR output is enabled for answered incoming/outgoing calls
Item 4: a 6-digit length is assigned to all Forced/Voluntary Account Codes
Item 5: Data = 0 All call
Item 6: Data is Blank
Item 9: Data = 1 Enabled
(QWHU 3URJ 0RGH 0 6SNU 93+ROG 0 6SNU +ROG 0 6SNU & & +R OG 0 6SNU & & +ROG
Item Description Data
2
SMDR Threshold Time
0 =1 second
1 = 10 seconds
Time
3
SMDR Output when a call is completed
0 = Outgoing Only
1 = Incoming and Outgoing
SMDR
4
Forced/Voluntary Account Code Digit Length 04~15
(See Program 69 for Verified Account Codes)
Digits are verified per Program 30, Button/LED 14 and
Program 69
Account
5
SMDR Printout Options
Toll Dial:
0 = All Calls (item 3, printout outgoing call only is still
available)
1 = Dial “0” calls only
2 = Dial “1” calls only
3 = Dial “00” calls only
4 = Dial “1”, “0” calls only
5 = Dial “1”, “00” calls only
Toll Dial Data
6
DISA Security Code
01~15 digits, may be changed from station, per Program 30
If a security code is not programmed, outgoing trunk access
via DISA will not require a security code when dialling.
Data
Button 01 =
blank
Button 02 is
wild card
(any digit from
1~9)
9
SMDR to Report on Abandoned Calls
0 = Disabled
1 = Enabled
See table below.SELECT = 2~6 & 9 (Item)
Make a selection from the table below.
To Next Page
Loading...
