Toshiba Strata DK40 - Program 12 System Assignments, Basic Timing; Program 12 Overview; Code 3: Pause Timing

Program 12 System Assignments, Basic Timing System & Station
Strata DK40 Programming Manual Spring 1999
3-29
Program 12
System Assignments, Basic Timing
Program Type:
System
Program 12 Overview
This program assigns system times for disconnecting calls, pause times, recall times, auto
attendant, DISA, Call Forward External and DTMF receiving decoding time.
Code 3: Pause Timing
Code 3 enables station users to program short and long pauses in Speed Dial numbers. The
short pause length can be set system wide for either 1.5 or 3 seconds with this program. The
long pause is always 10 seconds.
Initialised Default:
Program Timing
Code 3 1
Code 4 2
Code 5 0
Code 8 1
Code 9 4
(QWHU 3URJ 0RGH 0 6SNU 45+ROG 0 6SNU +ROG 0 6SNU & & +ROG 0 6SNU & & +ROG
Program
Code Function Code Time
Required
Code
3
Pause Timing
(Speed Dial)
11.5 sec
23.0 sec.
4
Recall Timing
10.5 sec.
22.0 sec.
30.1 sec.
40.2 sec.
5
Pause After Recall
(Voice Path Delay)
0 no pause
11.5 sec.
23.0 sec.
8
External Call Forward, and DISA
Disconnect Timer for Loop Start Lines
0 no disconnect timer
1 30 min. disconnect
2 60 min. disconnect
9
K5RCU3 DTMF Inter-digital Release
Time (Standard Phone)
1 1 sec.
through through
9 9 sec.
SELECT = Program Code
See table below.
SELECT CODE = Enter required code for the time listed in the table
below.
When programming Codes 8 and 9, the LCD responds with LINE TIME =,
instead of SELECT CODE =.