Program *63-2 Outdialling Inter Digit Pause
System & Station
Strata DK40 Programming Manual Spring 1999
3-123
Program *63-2
Outdialling Inter Digit Pause
Program Type:
System
Initialised Default:
04 (4 seconds)
Program *63-2 Overview
The DK40 system will offer a system wide “inter Digit Pause” time-out facility. The DK40
will start the outgoing call setup process when this timer expires. Once the DKT/EKT/2 wire
extension has dialled a valid trunk access code, the “time-out” is started. After every dialled
digit the timer is restarted. If no digit is received from the extension and time-out expires, the
system considers the number dialled as complete and will start to route the call. Any further
digits received from the extension are ignored until a “connect” message is received from the
local exchange.
Note
A very short time-out will require users to enter the dialled number very quickly and
delays by the user may result in calls failing due to “insufficient routing
information”. A long time-out will increase outgoing call setup times.
(QWHU 3URJ 0RGH 0 6SNU
*
96+ROG 0 6SNU 50+ROG 0 6SNU & & +ROG 0 6SNU & & +ROG
DATA Timeout Value DATA Timeout Value
00 No Internal Sub-Addressing 06 06 Seconds
01 01 Seconds 07 07 Seconds
02 02 Seconds 08 08 Seconds
03 03 Seconds 09 09 Seconds
04 04 Seconds 10 10 Seconds
05 05 Seconds
DATA = Duration of timeout. See legend below:
To Next Page
Loading...
