Toshiba Strata DK40 - Program 00 - Overview; Code 0, ROM Version; Code 1, Level 1 Security Code; Code 2, Level 2 Security Code

Initialisation & Test Program 00 Software Check
2-14
Strata DK40 Programming Manual Spring 1999
Program 00 - Overview
This program enables you to run various checks on the Strata DK40 System.
A KKYS, RKYS2 or RKYS3 feature key must be installed on the K5RCU PCB to allow AA,
AA & ACD, AA, ACD & MIS respectively.
Code 0, ROM Version
Code 0 displays the software version of the system common control unit DK40 Base KSU
and if installed on the K5RCU, the RKYS, KKYS key type. See the Program 00 Record
Sheet for an illustration of software displays. This information cannot be altered with this
program.
Code 1, Level 1 Security Code
Use to assign a Remote Maintenance security code that allows entry to all programs and data.
Code 2, Level 2 Security Code
Use this program to assign a Remote Maintenance security code that allows entry to
Programs 04, 27, 30~39, 77~89.
Important!
When using a DK Admin PC, either Security Code (1 or 2) enables the DK
Admin user full access to all Strata DK programs. Always change Security
Code 1 and Code 2 to prevent unauthorised programming changes by DK
Admin users that may try to log-in remotely with the default security code:
0000.
Code 3, UK & Ireland A Law Set
This sets the system for A law operation. This must always have DATA=04 value set.
Code 8, Software RAM Checksum
For factory purposes only.
Code 9, Power Cycle Counter
This shows the number of the times the systems power has been cycled since the system was
initialised (using Program 91-9).
Program 00 Part 1 - Example
Action (press buttons + LED Buttons) LCD Response
1. Use the programming LCD electronic or digital
telephone. (See “First-time Programming” on Page 1-18
for more information.)
No. N-N
1
20 Jan Sun 06:43
2.
-
&
-
&4
-
5
-
6
Enter programming mode. (Do not press [DN] button.)
Program Mode
Password = _____________