Program 92 Initialising Misc. Backup RAM
Initialisation & Test
Strata DK40 Programming Manual Spring 1999
2-9
Program 92
Initialising Misc. Backup RAM
Program Type:
Initialisation - Includes: Initialising Speed Dial Numbers, VM ID
Codes, Character Message Memory, Timed Reminders, Digital
Telephone Volume, Call Forward Backup RAM, and Station Lock
Codes
Initialised Default:
None
(QWH U 3UR J 0R GH 0 6SNU <5+ROG 0 6SNU +ROG 0 6SNU & & +ROG 0 6SNU & & +ROG
4 34 36 Clears Station Speed Dial, Voice Mail ID Codes, and LCD memos assigned to Station Speed Dial numbers.
5 34 37 Clears System Speed Dial and LCD memos assigned to System Speed Dial numbers.
6 35 36 Clears Character Message Memory (Station and System) and User Name/Number Display.
7 35 37 Clears Timed Reminders.
8 34 38 Resets digital telephone volume levels to initialised settings, specifically, speaker volume levels for Internal Calls
[DN], Tone/BGM, Busy Override (muted ring), and Ring volume to approximately mid-range on all DKTs. Program
92-5 does not affect digital telephone handset receiver volume levels. Use Program 27 to set off-hook digital
telephone handset receiver volume levels.
9 35 37 Clears all Lock ID codes that have been set.
;4 35 38 Creates Reference Table. Every time a new PCB or additional extension
is installed or the slot configuration is adjusted Program 92-81 must run
to update the reference table for fault diagnostics.
;5 36 38 Manual Test and Print via SMDR.
< 36 37 +ROG Power OFF 5
seconds; then Power
ON
Clears Call Forward and Message Waiting Memory (all stations). Program 92-9 does
not affect Call Forward External or Fixed Call Forward settings.
Clear more data
Enter programming mode. SELECT = Press
appropriate buttons as
shown below.
Exit programming mode.End Program 92.
To Next Page
Loading...
