Program 90 Initialise Programs 00~*99
Initialisation & Test
Strata DK40 Programming Manual Spring 1999
2-5
Program 90 Example
1
N-N is the Program Telephone [DN]
Action LCD Response
1. Use the LCD programming phone per Minimum Hardware
Requirements on Page 1-18.
No. N-N
1
20 Jan Sun 06:43
2. (QWHU 3U RJUDP PRGH E\ SUHVVLQJ
-
&
-
&4
-
5
-
6.
+'R QRW SUHVV >'1@ EXWWRQ1,
Program Mode
Password = ______________
3. (QWHU >3DVVZRUG@ +ROG
Enter the four digit password.
level 1 Program Access
4. 6SNU +6S HDNHU,<3+ROG
Access Program 90. System beeps after Spkr (Speaker) is
pressed to indicate program number may be entered.
Program = 90
Data Store
5. 6SNU +6S HDNHU,
Prepare the system for the programs to be initialised.
90 Select =
6. 33
--
<<. /(' EXWWRQV 34 ) 35
Enter Program numbers individually, followed by #, or in a
range. For a range, separate the low program number and
the high program number with an asterisk.
33
--
<< initialises all Programs 00~
*
99.
Star
*
Program memory follows Program 97.
90 Select = 00**99
Data Clr
7. +ROG
Secure data in system programming. LEDs 01 and 02 flash.
90 Select = 00**99
Data Programmed
8. 6 SNU +6SHDNHU,
Prepare system for another selection (go back to Step 6) or
exit Program 90 (continue with Step 8)
90 Select =
9. &&+ROG
Secure default data in system memory. LED 01 and 02
continue to flash.
90 Select = ##
Data Programmed
10. 6SNU +6SHDNHU,
Exit Program 90. Enter another program number (See
“Program 92 Example” on Page 2-10) or exit programming
mode (go to Step 10). System beeps to indicate it is exiting
Program 90.
Program =
11. &&+R OG
Exit programming mode.
The system will not allow the 6SNU +6SHDNHU, LED to light
to re-enter the programming mode.
No. N-N
20 Jan Sun 06:53
To Next Page
Loading...
