Program 05 Flexible Access Code Numbering
System & Station
Strata DK40 Programming Manual Spring 1999
3-9
Program 05
Flexible Access Code Numbering
Program Type:
System
Initialised Default:
See record sheet
(QWHU 3URJ 0RGH 0 6SNU 38+R OG 0 6S N U +ROG 0 6SNU & & +R OG 0 6SNU & & +ROG
Default
Access
Code Features Affected (N/A = Not Affected/ Cannot Change)
New
Access
Codes
0
Unused
1
Voice First/Tone First (Dial 1-N/A)
Door Phones: (#151~#159; #161~#163)
IMDU (#19)
Default [PDNs] (see Program 04)
Station LCD Messages (10~19-N/A)
Station Speed Dial Set (10~49-N/A)
2
Default [PDNs] (see Program 04)
Busy Override (Dial 2-N/A)
Do Not Disturb Override (Dial 2-N/A)
Off-hook Call Announce (2-N/A)
3
Default [PDNs] (see Program 04)
Executive Override (Dial 3-N/A)
All Call Voice Page (#30)
All Call Voice Page with External Spkrs
(#39)
External Page Zones 1~4 (#35~#38)
Group Page (Internal) (#311~#314)
4
Automatic Callback (Dial 4-N/A)
Exchange Line Queuing (Dial 4-N/A)
Station Number Display (#401)
Port Number Display (#402)
Hold (#41)
Hold Pickup (#42)
Automatic Busy Redial (Conf + #44)
Automatic Busy Redial Cancel (Int + #44)
Message Waiting Answer (#408)
Standard telephone Redial (44) or dial #
for feature access code
Recall (Cnf + #45)
Account Code Input (Cnf + #46)
T.R. Override/T. Class Code Input (Cnf + #47)
BGM Over Stations ON (#481)
BGM Over Stations OFF (#480)
BGM Over External Speakers ON (#491)(Station Port
000 only)
BGM Over External Speakers OFF (#490)(Station Port
000 only)
Cancel Message Waiting at Station (#409)
Retrieve Message Waiting (#408)
Access Code/Speed Dial Prefix (44 or #)
To store an Exchange line or feature access code in
Speed Dial memory from two wire phones without the
Speed Dial and Redial buttons, enter 44 + 7XXX instead
of # + 7XXX.
Start Key Trace #489 (Station Port 000 only)
Stop Key Trace #488 (Station Port 000 only)
Cancel Auto Call Back (#43)
Re-Enter Trunk to Trunk (#482)
5
Call Pickup Station (#5+Station No.),
Ringing Exchange or DDI line (#59)
Directed Pickup of Exchange Line on
Hold (#5+#7 XXX, XXX = 001~012),
Pick-up External Page (#5 +#30 or for
Zone Page #5+#35~#38)
Selected Group Pickup (#5+#320~#339)
Own Group(s) Pickup (#5+#34)
Pickup Ringing Line (#59)
SELECT = Access Code (1~9)
See the table below for standard access codes.
SPECIAL DIAL = New Access Codes
The first digit of access codes can be replaced by 2 digits.
Press LED Button 01 to enter blanks.
To Next Page
Loading...
