Least Cost Routing
Program 50-1 LCR Parameters
5-6
Strata DK40 Programming Manual Spring 1999
Program 50-1
LCR Parameters
Program Type:
Least Cost Routing
Initialised Default:
All LEDs OFF
Program 50-1 Overview
This program defines general operating parameters for LCR software.
◆ Program 40 denies Exchange line access via LCR, but denies all other access
methods.
◆ Program 41 allows Exchange line access via LCR, but denies all other outgoing
access methods: (#7001~#7012, 801~808, Line button).
◆ Toll Restricted standard telephones should be forced to dial outgoing calls via LCR.
This is to prevent Toll Restriction defeat when the K5RCU times out.
LED 01: Enable System LCR
LED 01 ON: LCR software is enabled system-wide.
LED 01 OFF: LCR software is disabled. None of the LCR programming referred to by this
section is recognised. Dial 9 access assigned in Program 16 is enabled.
LED 02: LCR Speed Up
LED 02 ON: LCR Call Speed Up enabled system-wide.
LED 02 OFF: LCR Call Speed Up is disabled system-wide.
Note
If LCR Speed Up is enabled, the call will automatically follow the local Route Plan
08 and override any local Toll Restriction set. In addition the ABR feature will not
operate correctly.
LED 03: Not Used
(QWHU 3URJ 0RGH 0 6SNU 83+ROG 0 6SNU 4 +ROG 0 6SNU & & +ROG 0 6SNU & & +ROG
LED X LED ON LED OFF LED
05
Warning Tone Last Choice Route Numbers No Warning Tone
05
04
Dial Tone After LCR Access Silent
04
03
Not Used Not Used
03
02
LCR Speed Up Not Enabled
02
01
Enable System LCR No LCR
01
Press LED Buttons for each LCR parameter
SELECT = 1
To Next Page
Loading...
