Toyota 2002 Camry - Page 1081

Adhesive
Adhesive
BO4420
B56908
A – A,B – B
C – C
B
A
C
A
B
C
a
b
a
b
a
b
70–10
–WINDSHIELD/WINDOWGLASS/MIRROR WINDSHIELD GLASS
2543Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
23. INSTALL WINDSHIELD GLASS
(a) Clean and shape the contact surface of the vehicle’s body
(1) Using a knife, cut away any rough areas of the body.
HINT:
Leave as much adhesive on the body as possible.
(2) Clean the cut surface of the adhesive with a piece
of shop rag saturated in cleaner.
(b) Position the glass.
(1) Using a suction rubber, place the glass in the correct position.
(2) Check that all the contacting parts of the glass rim are perfectly even.
(3) Place reference marks between the glass and body.
NOTICE:
Check that the stoppers are attached to the body correctly.
HINT:
When reusing the glass, check and correct the reference mark’s positions.
(4) Remove the glass.
(c) Coat the contact surface of the back door with Primer M.
(d) Using a bursh, coat the exposed part of the contact surface on the vehicle side with Primer M.
NOTICE:
 Dry the primer coating for 3 minutes or more.
 Do not coat the adhesive with Primer M.
 Do not apply too much Primer.
(e) Coat the contact surface of the glass with Primer G.
(1) Using a brush or sponge, coat the edge of the glass and the contact surface with Primer G.
NOTICE:
 Dry the primer coating for 3 minutes or more.
 Do not apply too much primer.
(f) Apply adhesive.
(1) Cut off the tip of the cartridge nozzle as shown in the
illustration.
Part No. 08850–00801 or equivalent
HINT:
After cutting off the tip, use all adhesive within the time de-
scribed in the table below.
Temperature Tackfree time
35C (95F) 15 minutes
20C (68F) 100 minutes
5C (41F) 8 hours
(2) Load the sealer gun with the cartridge.
(3) Coat the glass with adhesive, as shown in the il-
lustration.
a: 8 mm (0.31 in.)
b: 12 mm (0.47 in.)