Toyota 2002 Camry - Page 1082

–WINDSHIELD/WINDOWGLASS/MIRROR WINDSHIELD GLASS
70–11
2544Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(g) Install the glass.
(1) Using a suction rubber, position the glass so that the reference marks are alined, and press it
in gently along the rim.
NOTICE:
 Dry the primer coating for 3 minutes or more.
 Check that the stoppers are attached to the body correctly.
 Check the clearance between the body and glass.
(2) Lightly press the glass front surface for close contact.
(3) Using a scraper remove any excess or protruding adhesive.
HINT:
Apply adhesive on the glass rim.
24. INSTALL WINDSHIELD MOULDING OUTER UPPER
(a) Install a new windshield moulding to the windshield glass before the adhesive has hardened.
(b) Hold the
windshield glass in place securely with protective tape or equivalent until the adhesive has
completely hardened.
(c) Using a scraper, remove any excess or protruding adhesive before the adhesive has hardened.
NOTICE:
Take care not to drive the vehicle during the time described in the table below.
Temperature Tackfree time
35C (95F) 1.5 hours
20C (68F) 5 hours
5C (41F) 24 hours
25. WATER–LEAK CHECK AND REPAIREMENT
(a) Conduct a leak test after the adhesive has completely hardened.
(b) Seal any leak with sealant.