Toyota 2002 Camry - Page 470

C66721
C81547
F40197
Inner side
Rear
side
26–20
–FRONT SUSPENSION STABILIZER BAR FRONT
1932Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
8. DISCONNECT TIE ROD ASSY RH
SST 09628–62011
HINT:
Separate the RH side by the same procedures with the LH side.
9. DISCONNECT STEERING GEAR OUTLET RETURN TUBE
(See page 51–29)
SST 09023–00100
10. DISCONNECT PRESSURE FEED TUBE ASSY
(See page 51–29)
SST 09023–00100
11. DISCONNECT STEERING INTERMEDIATE SHAFT SUB–ASSY
(See page 51–29)
12. REMOVE RACK & PINION POWER STEERING GEAR ASSY
(See page 51–29)
13. REMOVE STABILIZER BAR FRONT
14. REMOVE FRONT STABILIZER BAR BUSH NO.1
15. INSPECT FRONT STABILIZER LINK ASSY LH
(a) As shown in the illustration, flip the ball joint stud back and
forth 5 times, before installing the nut.
(b) Using a torque wrench, turn the nut continuously at a rate
of 2 – 4 seconds per 1 turn and take the torque reading
on the 5th turn.
Turning torque:
0.05 – 1.96 N·m (0.5 – 20 kgf·cm, 0.4 – 17.4 in.·lbf)
16. INSTALL FRONT STABILIZER BAR BUSH NO.1
HINT:
Install the bushing to the inner side of the bushing stopper on
the stabilizer bar.
17. INSTALL STABILIZER BAR FRONT
18. INSTALL RACK & PINION POWER STEERING GEAR ASSY
(See page 51–29)
19. INSTALL STEERING INTERMEDIATE SHAFT SUB–ASSY
(See page 51–29)
20. INSTALL PRESSURE FEED TUBE ASSY
(See page 51–29)
SST 09023–00100