Toyota 2002 Camry - Page 471

C91607
F40143
–FRONT SUSPENSION STABILIZER BAR FRONT
26–21
1933Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
21. INSTALL STEERING GEAR OUTLET RETURN TUBE
(See page 51–29)
SST 09023–00100
22. INSTALL TIE ROD ASSY LH
(See page 30–8)
23. INSTALL TIE ROD ASSY RH
HINT:
Install the RH side by the same procedures with the LH side.
24. INSTALL FRONT STABILIZER BRACKET NO.1 LH
(a) Install the 2 front stabilizer brackets No. 1 LH with the 2
bolts.
Torque: 19 N⋅m (194 kgf⋅cm, 14 ft⋅lbf)
25. INSTALL FRONT STABILIZER BRACKET NO.1 RH
HINT:
Install the RH side by the same procedures with the LH side.
26. INSTALL FRONT SUSPENSION MEMBER DYNAMIC DAMPER(EXCEPT 1MZ–FE ENGINE TYPE)
(a) Install the front suspension member dynamic damper with 2 bolts to the front frame assy.
Torque: 29 N⋅m (296 kgf⋅cm, 21 ft⋅lbf)
27. INSTALL FRONT STABILIZER LINK ASSY LH
(a) Install the front stabilizer link assy LH with the 2 nuts.
Torque: 74 N⋅m (755 kgf⋅cm, 55 ft⋅lbf)
HINT:
If the ball joint turns together with the nut, use a hexagon (6 mm)
wrench to hold the stud.
28. INSTALL FRONT STABILIZER LINK ASSY RH
HINT:
Install the RH side by the same procedures with the LH side.
29. INSTALL FRONT WHEEL
Torque: 103 N⋅m (1,050 kgf⋅cm, 76 ft⋅lbf)
30. BLEED POWER STEERING FLUID(See page 51–3)
31. CHECK POWERSTEERING FLUID LEAKAGE
32. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT(See page 26–5)