C92182
C66631
27–8
–REAR SUSPENSION SHOCK ABSORBER ASSY REAR LH
1941Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(d) Tighten the nut in the center of suspension support.
Torque: 49 N⋅m (500 kgf⋅cm, 36 ft⋅lbf)
HINT:
If the shock absorber has not been disassembled, it is neces-
sary to torque the nut.
(e) Install the rear suspension support No. 1cover LH.
17. INSTALL REAR STABILIZER LINK ASSY LH
(a) Install the stabilizer bar link to the shock absorber with the
nut.
Torque: 39 N⋅m (400 kgf⋅cm, 29 ft⋅lbf)
HINT:
If the ball joint turns together with the nut, use a hexagon (5 mm)
wrench to hold the stud.
18. INSTALL REAR SEAT 3 POINT TYPE BELT ASSY OUTER
(a) TMC made: (See page 61–14)
(b) TMMK made: (See page 61–17)
19. INSTALL REAR SIDE SEAT BACK ASSY RH
(a) TMC made: (See page 72–34)
(b) TMMK made: (See page 72–38)
20. INSTALL REAR SIDE SEAT BACK ASSY LH
HINT:
Install the LH side by the same procedures with the RH side.
21. INSTALL REAR WHEEL
Torque: 103 N⋅m (1,050 kgf⋅cm, 76 ft⋅lbf)
22. INSPECT REAR WHEEL ALIGNMENT(See page 27–3)
To Next Page
Loading...
