Toyota 2002 Camry - Page 484

C91813
C82996
C82997
–REAR SUSPENSION REAR SUSPENSION ARM ASSY NO.1 LH
27–13
1946Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
18. STABILIZE SUSPENSION
(a) Jack up the rear axle carrier, placing a wood block be-
tween them. Apply load to the suspension so that the
installed bolt of the suspension arm assy No. 1 (vehicle
side) is horizontally aligned with the center of the rear axle
hub.
19. FULLY TIGHTEN REAR SUSPENSION ARM ASSY
NO.1 LH
(a) Fully tighten the bolt.
Torque: 100 N⋅m (1,020 kgf⋅cm, 74 ft⋅lbf)
HINT:
Keep the nut fixed while tightening the bolt.
20. FULLY TIGHTEN REAR SUSPENSION ARM ASSY NO.1 RH
HINT:
Fully tighten the RH side by the procedures with the LH side.
21. FULLY TIGHTEN REAR SUSPENSION ARM ASSY
NO.2 LH
(a) Fully tighten the bolt.
Torque: 100 N⋅m (1,020 kgf⋅cm, 74 ft⋅lbf)
HINT:
Keep the nut fixed while tightening the bolt.
22. FULLY TIGHTEN REAR SUSPENSION ARM ASSY NO.2 RH
HINT:
Fully tighten the RH side by the procedures with the LH side.
23. FULLY TIGHTEN STRUT ROD ASSY REAR
(See page 27–19)
24. INSTALL STABILIZER BAR REAR
(See page 27–17)
25. INSTALL EXHAUST PIPE ASSY CENTER
(a) 1MZ–FE engine: See page 15–5
(b) 2AZ–FE engine: See page 15–2
26. INSTALL REAR WHEEL
Torque: 103 N⋅m (1,050 kgf⋅cm, 76 ft⋅lbf)
27. INSPECT REAR WHEEL ALIGNMENT(See page 27–3)