C66549
C92143
SST
C91598
F07391
30–10
–DRIVE SHAFT / PROPELLER SHAFT FRONT DRIVE SHAFT
1964Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
11. REMOVE FRONT DRIVE SHAFT ASSY RH
(a) Using a pliers, remove the drive shaft bearing bracket
hole snap ring.
(b) Remove the bolt and front drive shaft assy RH from the
drive shaft bearing bracket.
12. FIX FRONT AXLE ASSY LH
NOTICE:
The hub bearing could be damaged if it is subjected to the
vehicle weight, such as when moving the vehicle with the
drive shaft removed.
Therefore, if it is absolutely necessary to place the vehicle
weight on the hub bearing, first support it with SST.
SST 09608–16042 (09608–02021, 09608–02041)
13. INSPECT FRONT DRIVE SHAFT ASSY LH
(a) Check to see that there is no remarkable play in the out-
board joint.
(b) Check to see that the inboard joint slides smoothly in the
thrust direction.
(c) Check to see that there is no remarkable play in the radial
direction of the inboard joint.
(d) Check the boots for damage.
NOTICE:
Move the drive shaft assy keeping it level.
14. REMOVE FRONT AXLE INBOARD JOINT BOOT
CLAMP
(a) Using pliers, pinch the claws to compress the front axle
inboard joint boot LH No.2 clamp and remove it.
(b) Using a side cutter, cut the front axle inboard joint boot LH
clamp and remove it.
15. DISCONNECT FR AXLE INBOARD JOINT BOOT
To Next Page
Loading...
