Toyota 2002 Camry - Page 510

C83851
C66548
F40142
30–18
–DRIVE SHAFT / PROPELLER SHAFT FRONT DRIVE SHAFT
1972Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
41. INSTALL FRONT DRIVE SHAFT ASSY LH
(a) Coat the spline of the front drive inboard joint assy LH with
ATF.
(b) Aline the shaft splines and install the front drive shaft assy
LH with brass bar and hammer.
NOTICE:
 Set the snap ring with opening side facing downward.
 Be careful not to damage the oil seal.
HINT:
Whether the front drive inboard joint assy LH is in contact with
the pinion shaft or not can be known from the sound or feeling
when driving it.
42. INSTALL FRONT DRIVE SHAFT ASSY RH
(a) Using a screwdriver, install the drive shaft bearing bracket
hole snap ring.
(b) Install the bolt.
Torque: 32.4 N⋅m (330 kgf⋅cm, 24 ft⋅lbf)
NOTICE:
Do not damage the oil seal.
43. INSTALL FRONT AXLE ASSY LH
(a) Install the front drive shaft assy LH to the front axle assy LH.
NOTICE:
 Be careful not to damage the outboard joint boot.
 w/ ABS:
Be careful not to damage the speed sensor rotor.
44. INSTALL FRONT SUSPENSION ARM SUB–ASSY
LOWER NO.1 LH
(a) Install the lower ball joint assy front LH to the front suspen-
sion arm sub–assy lower No. 1 LH with the bolt and nut.
Torque: 127 N⋅m (1,295 kgf⋅cm, 94 ft⋅lbf)
45. INSTALL TIE ROD ASSY LH
(a) Install the tie rod assy LH to the steering knuckle LH with the nut.
Torque: 49 N⋅m (500 kgf⋅cm, 36 ft⋅lbf)