Toyota 2002 Camry - Page 516

F40155
C83023
30–24
–DRIVE SHAFT / PROPELLER SHAFT FRONT AXLE HUB SUB–ASSY LH
1978Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
17. INSTALL FRONT AXLE HUB LH HOLE SNAP RING
(a) Using snap ring plier, install a new front axle hub LH hole
snap ring.
18. INSTALL LOWER BALL JOINT ASSY FRONT LH
(a) Install the lower ball joint assy front LH and tighten the nut.
Torque: 123 N⋅m (1,254 kgf⋅cm, 91 ft⋅lbf)
(b) Install a new cotter pin.
NOTICE:
If the holes for the cotter pin are not aligned, tighten the nut further up to 60.
19. INSTALL FRONT AXLE ASSY LH
(a) Install the 2 bolts, nuts and front axle assy LH to the shock
absorber assy front LH.
Torque: 210 N⋅m (2,141 kgf⋅cm, 155 ft⋅lbf)
HINT:
Insert the bolt from the rear side of the vehicle and tighten the
nut.
(b) Push the front axle assy LH toward the outside of the ve-
hicle, fit the splined part of the front drive shaft assy LH
to that of the front axle assy LH and insert the front drive
shaft assy LH into the front axle assy LH.
NOTICE:
 Do not push out the front axle assy LH excessively.
 Be careful not to damage the outboard joint boot.
 w/ ABS:
Be careful not to damage the speed sensor rotor.
20. INSTALL FRONT SUSPENSION ARM SUB–ASSY LOWER NO.1 LH
(See page 30–8)
21. INSTALL TIE ROD ASSY LH
(See page 30–8)
22. INSTALL FRONT DISC