Toyota 2002 Camry - Page 703

C69773
C83258
–MANUAL TRANSMISSION/TRANSAXLE MANUAL TRANSAXLE ASSY (E351)
41–35
2165Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(g) Turn the output shaft in both directions to make it smooth.
(h) Using a socket wrench and torque wrench, inspect the
preload.
Preload: N⋅m (kgf⋅cm, in.⋅lbf)
Bearing Torque
New 0.8 – 1.6 (8.16 – 16.32, 7.1 – 14.2)
Used 0.5 – 1.0 (5.10 – 10.20, 4.4 – 8.9)
(i) If the preload is out of the specification, select the output
shaft rear bearing shim and adjust it.
HINT:
The preload of the output shaft rear bearing shim varies in
torque from about 0.04 to 0.06 N⋅m in one size.
Shim: mm (in.)
Part No. thickness: mm (in.) Make
90564–59001 1.30 (0.0512) 0
90564–59002 1.35 (0.0531) 1
90564–59003 1.40 (0.0551) 2
90564–59004 1.45 (0.0571) 3
90564–59005 1.50 (0.0591) 4
90564–59006 1.55 (0.0610) 5
90564–59007 1.60 (0.0630) 6
90564–59008 1.65 (0.0650) 7
90564–59009 1.70 (0.0669) 8
90564–59010 1.75 (0.0689) 9
90564–59011 1.80 (0.0709) A
90564–59012 1.85 (0.0728) B
90564–59013 1.90 (0.0748) C
90564–59014 1.95 (0.0768) D
90564–59015 2.00 (0.0787) E
90564–59016 2.05 (0.0807) F
90564–59017 2.10 (0.0827) G
90564–59018 2.15 (0.0846) H
90564–59019 2.20 (0.0866) J
90564–59020 2.25 (0.0886) K
90564–59021 2.30 (0.0906) L
90564–59022 2.35 (0.0925) M
90564–59023 2.40 (0.0945) N
90564–59024 2.45 (0.0965) P
90564–59025 2.50 (0.0984) Q
(j) Remove the output shaft rear set nut from the output
shaft.
(k) Using a torx socket wrench (T45), remove the 7 screws
and bearing retainer RR from the manual transmission
case.