C69549
C70515
C92867
SST
C69551
–MANUAL TRANSMISSION/TRANSAXLE INPUT SHAFT ASSY (E351)
41–53
2183Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
4. INSPECT 3RD GEAR RADIAL CLEARANCE
(a) Using a dial indicator, measure the 3rd gear radial clear-
ance.
Standard clearance: mm (in.)
Bearing Standard clearance
KOYO made
0.009 – 0.053
(0.0004 – 0.0021)
NSK made
0.009 – 0.051
(0.0004 – 0.0020)
If the clearance exceeds the maximum, replace the 3rd gear
needle roller bearing.
5. REMOVE 4TH GEAR
(a) Hold the input shaft assy and soft jaws with a vise.
(b) Using a 2 screwdrivers and a hammer, remove the input
shaft rear bearing shaft snap ring from the input shaft.
NOTICE:
Using a waste to prevent the snap ring from being scat-
tered.
(c) Using SST and a press, remove the input shaft rear bear-
ing and 4th gear.
SST 09950–00020
NOTICE:
Do not tighten SST excessively.
6. REMOVE 4TH GEAR NEEDLE ROLLER BEARING
(a) Remove the 4th gear needle roller bearing from the input
shaft.
To Next Page
Loading...
