Toyota 2002 Camry - Page 763

D26270
CL0528
D26270
D05852
Protrusion
1.5 – 3.5 mm
(0.059 – 0.138 in.)
42–10
–CLUTCH CLUTCH MASTER CYLINDER ASSY
2225Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(f) While pushing the piston rod, using snap ring pliers, re-
move the snap ring.
(g) Remove the push rod from the cylinder body.
NOTICE:
The piston may pop up out of the cylinder body. Therefore,
slowly remove the push rod from the cylinder body.
(h) Remove the stop plate from the push rod.
(i) Remove the piston with spring from the cylinder.
NOTICE:
Be careful not to damage the inside of the cylinder body.
9. INSTALL CLUTCH MASTER CYLINDER KIT
(a) Coat parts with lithium soap base glycol grease, shown in
the illustration.
(b) Install the piston with spring into the cylinder.
NOTICE:
Be careful not to damage the inside of the cylinder body.
(c) Install the stop plate to the push rod.
(d) Install the push rod to the cylinder body.
(e) While pushing the piston rod, using snap ring pliers, install
the snap ring.
(f) Install the boot to the cylinder body.
(g) Install the lock nut to the push rod.
(h) Temporarily install the push rod clevis with the lock nut to
the push rod.
(i) Install the inlet union and a new grommet.
(j) Using a pin punch (φ 5 mm) and hammer, drive in the
slotted spring pin.
10. INSTALL CLUTCH MASTER CYLINDER ASSY
(a) Install the clutch master cylinder assy with the 2 nuts.
Torque: 11.8 N⋅m (120 kgf⋅cm, 9 ft⋅lbf)