D08944
Flywheel
Side
SST
D08945
6
2
5
7
SST
Matchmarks
1, 4
3
D08946
SST
42–16
–CLUTCH CLUTCH UNIT
2231Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
13. INSTALL CLUTCH DISC ASSY
(a) Insert SST in the clutch disc assy, then insert them in the
flywheel sub–assy.
SST 09301–00220
NOTICE:
Take care not to insert clutch disc assy in the wrong direc-
tion.
14. INSTALL CLUTCH COVER ASSY
(a) Align the matchmarks on the clutch cover assy and fly-
wheel sub–assy.
(b) Following the procedures shown in the illustration, tighten
the 6 bolts, in the order starting the bolt locating near the
knock pin on the top.
Torque: 19.1 N⋅m (195 kgf⋅cm, 14 ft⋅lbf)
HINT:
Following the order in the illustration, tighten the bolts at
a time evenly.
Move SST up and down, right and left lightly, after check-
ing that the disc is in the center, tighten the bolts.
15. INSPECT AND ADJUST CLUTCH COVER ASSY
(a) Using a dial indicator with roller instrument, check the dia-
phragm spring tip alignment.
Maximum non–alignment: 0.5 mm (0.020 in.)
If alignment is not as specified, using SST, adjust the dia-
phragm spring tip alignment.
SST 09333–00013
16. INSTALL RELEASE FORK SUPPORT
(a) Install the release fork support to the manual transaxle assy.
Torque: 47.1 N⋅m (480 kgf⋅cm, 35 ft⋅lbf)
17. INSTALL RELEASE BEARING HUB CLIP
(a) Install the release bearing hub clip to the release bearing assy.
To Next Page
Loading...
