C92656
474.5 1 mm (18.681 0.039 in.)
C92306
C92363
Screw Extractor
C92358
–STEERING COLUMN STEERING COLUMN ASSY (TMC MADE)
50–13
2248Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
27. INSPECT STEERING COLUMN ASSY
(a) Measure the length of steering main shaft.
Standard length: 474.5 1 mm (18.681 0.039 in.)
28. REMOVE TRANSPONDER KEY AMPLIFIER(W/
ENGINE IMMOBILISER SYSTEM)
(a) Disengage the claw hung on the upper bracket with a
screwdriver.
(b) Pull the transponder key amplifier toward the rear of the
vehicle with the claw open.
NOTICE:
Take care not to apply excessive force to prevent the case
from being damaged.
29. REMOVE KEY CYLINDER LAMP ASSY(W/ ILLUMINATED ENTRY SYSTEM)
30. REMOVE STEERING COLUMN UPPER W/SWITCH
BRACKET ASSY
(a) Using a centering punch, mark the center of the 2 lap-
ered–head bolts.
(b) Using a 3 – 4 mm (0.12 – 0.16 in.) drill, drill into the 2 bolts.
(c) Using a screw extractor, remove the 2 bolts and steering
column upper w/ switch bracket assy.
31. REMOVE STEERING COLUMN CLAMP UPPER
32. REMOVE STEERING MAIN SHAFT ASSY
(a) Using a snap ring expander, remove the steering main
shaft snap ring (outer side).
To Next Page
Loading...
