C92307
F40490
C90811
C90812
50–14
–STEERING COLUMN STEERING COLUMN ASSY (TMC MADE)
2249Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(b) Using a brass bar and a hammer, remove the steering
main shaft assy and steering main shaft radial ball bear-
ing.
NOTICE:
Be careful not to drop the steering main shaft assy.
(c) Using a snap ring expander, remove the steering main
shaft snap ring (inner side).
33. REMOVE IGNITION SWITCH LOCK CYLINDER ASSY
(a) Place the ignition switch lock cylinder assy at the ACC
position.
(b) Push down the stop pin with a screwdriver, and pull out
the cylinder assy.
34. REMOVE UN–LOCK WARNING SWITCH ASSY
(a) Disconnect the un–lock warning switch assy connector
from the ignition or starter switch assy.
(b) Remove the un–lock warning switch assy.
35. REMOVE IGNITION OR STARTER SWITCH ASSY
(a) Remove the 2 screws and ignition or starter switch assy from the steering column bracket assy.
36. INSTALL IGNITION OR STARTER SWITCH ASSY
(a) Install the ignition or starter switch assy to the steering column bracket assy with the 2 screws.
To Next Page
Loading...
