Toyota 2002 Camry - Page 788

C90812
C92359
C92358
–STEERING COLUMN STEERING COLUMN ASSY (TMC MADE)
50–15
2250Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
37. INSTALL UN–LOCK WARNING SWITCH ASSY
(a) Install the un–lock warning switch assy.
(b) Connect the un–lock warning switch assy connector to
the ignition or starter switch assy.
38. INSTALL IGNITION SWITCH LOCK CYLINDER ASSY
(a) Make sure that the ignition switch lock cylinder assy is at the ACC position.
(b) Install the ignition switch lock cylinder assy.
39. INSPECT STEERING LOCK OPERATION
(a) Check that the steering lock mechanism is activated when removing the key.
(b) Check that the steering lock mechanism is deactivated when inserting the key and turning it to ACC
position.
40. INSTALL STEERING MAIN SHAFT ASSY
(a) Using a snap ring expander, install a new steering main
shaft snap ring (inner side) to the steering main shaft
assy.
(b) Install the steering main shaft assy to the steering column
tube.
(c) Using a snap ring expander, install a new steering main
shaft snap ring (outer side) to the steering main shaft
assy.