Toyota 2002 Camry - Page 789

C92360
SST
C93841
C92306
C92362
Matchmarks
50–16
–STEERING COLUMN STEERING COLUMN ASSY (TMC MADE)
2251Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
41. INSTALL STEERING MAIN SHAFT RADIAL BALL
BEARING
(a) Using SST and a hammer, install a new steering main ra-
dial ball bearing.
SST 09608–06041
42. INSTALL STEERING COLUMN UPPER W/SWITCH
BRACKET ASSY
(a) Temporarily install the steering column upper w/switch
bracket assy and steering column upper clamp with 2 new
tapered–head bolts.
(b) Tighten the 2 tapered–head bolts until the bolt heads
break off.
43. INSTALL KEY CYLINDER LAMP ASSY(W/ ILLUMINATED ENTRY SYSTEM)
44. INSTALL TRANSPONDER KEY AMPLIFIER(W/
ENGINE IMMOBILISER SYSTEM)
(a) Align the transponder key amplifier with the installation
position of the upper bracket with the amplifier inclined.
(b) Push the trasponder key amplifier up and connect it to the
upper bracket.
NOTICE:
Take care not to push the amplifier up with excessive force
to prevent it from being damaged.
45. INSTALL STEERING SLIDING YOKE SUB–ASSY
(a) Align the matchmark with the one on the steering sliding
yoke sub–assy and steering main shaft assy.
(b) Install the steering sliding yoke sub–assy with the bolt.
Torque: 35.3 N⋅m (360 kgf⋅cm, 26 ft⋅lbf)