Toyota 2002 Camry - Page 830

F41599
A
B
W03441
F41567
Pressure
Feed
Tube
Stopper
–POWER STEERING VANE PUMP ASSY (1MZ–FE)
51–25
2292Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
47. INSTALL VANE PUMP ASSY
(a) Temporarily install the vane pump assy with the 2 (A and
B) bolts.
48. INSTALL VANE PUMP V BELT
(a) Install the vane pump V belt and adjust the V belt tension
(See page 14–140).
(b) Torque the bolt A.
Torque: 43 N⋅m (438 kgf⋅cm, 32 ft⋅lbf)
(c) Torque the bolt B.
Torque: 43 N⋅m (438 kgf⋅cm, 32 ft⋅lbf)
49. CONNECT PRESSURE FEED HOSE
(a) Using a spanner (24 mm) to hold the pressure port union,
connect the pressure feed tube assy with the union bolt
and a new gasket.
Torque: 51.5 N⋅m (525 kgf⋅cm, 38 ft⋅lbf)
HINT:
Make sure the stopper of the pressure feed tube touches the
front bracket as shown in the illustration, then install the union
bolt.
50. INSTALL POWER STEERING OIL PRESSURE SWITCH
(a) Install the power steering oil pressure switch to the union bolt.
Torque: 21 N⋅m (214 kgf⋅cm, 15 ft⋅lbf)
NOTICE:
Be careful not to prevent oil from being attached to the connector.
(b) Connect the connector.
51. CONNECT OIL RESERVOIR TO PUMP HOSE NO.1
(a) Connect the oil reservoir to pump hose No.1.
(b) Install the clip.
52. INSTALL FRONT FENDER APRON SEAL RH
53. INSTALL FRONT FENDER LINER RH
54. INSTALL FRONT WHEEL RH
Torque: 103 N⋅m (1,050 kgf⋅cm, 76 ft⋅lbf)
55. BLEED POWER STEERING FLUID
56. INSPECT FLUID LEAK