Toyota 2002 Camry - Page 829

F41492
F41600
SST
51–24
–POWER STEERING VANE PUMP ASSY (1MZ–FE)
2291Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
39. MEASURE PS VANE PUMP ROTATION
TORQUE(TYPE B VANE PUMP)
(a) Check that the vane pump rotates smoothly without ab-
normal noise.
(b) Temporarily install the service bolt.
Recommended service bolt:
Thread diameter: 10 mm (0.39 in.)
Thread pitch: 1.25 mm (0.0492 in.)
Bolt length: 50 mm (1.97 in.)
(c) Using a torque wrench, check the vane pump rotating
torque.
Rotating torque:
0.27 N⋅m (2.8 kgf⋅cm, 2.4 in.⋅lbf) or less
40. INSTALL VANE PUMP BRACKET REAR(TYPE A VANE PUMP)
(a) Install the vane pump bracket rear with the 2 bolts.
Torque: 43 N⋅m (438 kgf⋅cm, 32 ft⋅lbf)
41. INSTALL VANE PUMP BRACKET REAR(TYPE B VANE PUMP)
(a) Install the vane pump bracket rear with the 2 bolts and 2 nuts.
Torque: 44 N⋅m (449 kgf⋅cm, 32 ft⋅lbf)
42. INSTALL FLOW CONTROL VALVE COMPRESSION SPRING
(a) Coat the flow control valve compression spring with power steering fluid and install it.
43. INSTALL FLOW CONTROL VALVE
(a) Coat the flow control valve with power steering fluid.
(b) Install the flow control valve.
44. INSTALL PRESSURE PORT UNION
(a) Coat a new O–ring with power steering fluid and install it to the pressure port union.
(b) Install the pressure port union.
Torque: 83 N⋅m (846 kgf⋅cm, 61 ft⋅lbf)
45. INSTALL POWER STEERING SUCTION PORT UNION
(a) Coat a new O–ring with power steering fluid and install it to the power steering suction port union.
(b) Install the power steering suction port union with the bolt.
Torque: 13 N⋅m (133 kgf⋅cm, 10 ft⋅lbf)
46. INSTALL VANE PUMP PULLEY(TYPE A VANE PUMP)
(a) Install the vane pump pulley to the vane pump shaft.
(b) Using SST, stop the vane pump pulley rotation and install
the nut.
SST 09960–10010 (09962–01000, 09963–01000)
Torque: 44 N⋅m (449 kgf⋅cm, 32 ft⋅lbf)