Toyota 2002 Camry - Page 828

F04644
Round End
Gasket
F41480
Set
R11292
F41573
–POWER STEERING VANE PUMP ASSY (1MZ–FE)
51–23
2290Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(b) Coat 10 vane pump plates with power steering fluid.
(c) Install the vane pump plates with the round end facing
outward.
(d) Install a new gasket.
36. INSTALL VANE PUMP SIDE PLATE REAR
(a) Coat a new O–ring with power steering fluid and install it
to the vane pump side plate rear.
(b) Align the groove of the vane pump cam ring with that of
the vane pump side plate rear, install the vane pump side
plate rear.
(c) Install the wave washer so that its protrusions fit into the
slots in the vane pump side plate rear.
37. INSTALL VANE PUMP HOUSING REAR
(a) Coat a new O–ring with power steering fluid and install it to the vane pump housing rear.
(b) Install the vane pump housing rear with the 4 bolts.
Torque: 24 N⋅m (245 kgf⋅cm, 18 ft⋅lbf)
38. MEASURE PS VANE PUMP ROTATION
TORQUE(TYPE A VANE PUMP)
(a) Check that the vane pump rotates smoothly without ab-
normal noise.
(b) Temporarily install the pulley set nut.
(c) Using a torque wrench, check the vane pump rotating
torque.
Rotating torque:
0.27 N⋅m (2.8 kgf⋅cm, 2.4 in.⋅lbf) or less