Toyota 2002 Camry - Page 844

F05730
Vinyl Tape
Power Steering
Rack Bush
F40546
Cylinder
End Stopper
Wire
F41507
SST
F40912
SST
SST
F40913
SST
–POWER STEERING RACK & PINION POWER STEERING GEAR ASSY
51–39
2306Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(c) To prevent rack bush oil seal lip damage, wind vinyl tape
around the power steering rack end, and apply power
steering fluid.
(d) Install the power steering rack bush to the power steering
rack.
43. INSTALL CYLINDER END STOPPER
(a) Align the installation hole for the wire of the cylinder end
stopper with the slot of the rack housing.
(b) Install a new wire into the cylinder end stopper.
(c) Using a screwdriver, turn the cylinder end stopper clock-
wise by 450  50.
44. AIR TIGHTNESS TEST
(a) Install SST to the rack housing.
SST 09631–12071 (09633–00010)
(b) Apply vacuum of 53 kPa (400 mmHg, 15.75 in.Hg) for
about 30 seconds.
(c) Check that there is no change in the vacuum.
If there is a change in the vacuum, check the installation of the
oil seals.
45. INSTALL POWER STEERING CONTROL VALVE
UPPER OIL SEAL
(a) Coat a control valve upper bearing and a new power
steering control valve upper oil seal with power steering
fluid.
(b) Using SST and a press, install the power steering control
valve upper oil seal.
SST 09950–70010 (09951–07150), 09950–60010
(09951–00180, 09952–06010, 09951–00320)
(c) Using SST and a press, install the control valve upper
bearing.
SST 09950–70010 (09951–07150), 09950–60010
(09951–00180, 09952–06010, 09951–00340)